So now that you have some knowledge on the types of Prochargers and tools you may need for the installation of bringing your mustang to the next level. So here is the process of doing the installation.
1- Remove the front clip of the car
2- Remove the serpentine belt
3- Remove the 3 head bolts below valve cover "18mm"
4- Mount the procharger for a "mock-up" design
5- Convert the "MAF" (Mass Air Flow) 3 wire into a 4 wire MAF pigtail "if yours was one of the cars that had a 3 wire MAF
6- Decide if you want to run MAF as a Blow Thru or Draw Thru System
7- Cut out about 2" out of the fender hole by MAF to route your air filter.
NOW Proceed to look at the steps on the left side of the screen to further install.